PREPARING Dialytic Water:

Dialytic Water can be easily prepared using the ampoules of the SLACKSTONE II^® System and this method has been perfected based on our experiences since 1966 and on the results obtained:

1.- It is used in a preferably tall glass of approximately a quarter of a liter (250 c.c.) of ordinary, natural water.

1.1: Mineral water can be used if preferred, but this is only necessary in areas where tap water is very hard. As a general norm, we can use the water normally used to prepare food.

1.2: The use of herbal tisanes in the preparation of Dialytic Water, is not advisable, although these can, of course, be taken at another time.

2.- The SLACKSTONE II^® ampoule must remain submerged within the water for 24 hours, and the thickest part of the ampoule must be totally covered.

The ampoule should be not opened or used if broken, as the energy generated by the crystals inside this can pass through the glass perfectly well and from there be transmitted to the water. (The ampoule works in the same way as a normal battery used in electrical appliances).

The yellowish color of the crystals contained within the ampoule is normal.

Take care not to heat, refrigerate or shake the water prepared in this way, as this will alter its action.

If necessary, it is a good idea to cover the glass with a cloth or a piece of plastic to stop dust, insects, etc. from falling inside.

3.- The activated Dialytic Water should be taken immediately after the ampoule has been removed.

4.- Refill the glass with water and insert the ampoule again to prepare the next dose to be taken in 24 hours.

5.- Each ampoule can be used to prepare 40 glasses of Dialytic Water or what is the same, a box of SLACKSTONE II^® (containing 2 ampoules) can be used to prepare 20 liters of Dialytic Water. After this amount is prepared, the energy emitted by the ampoule decreases considerably until it completely wears out.

We recommend you use the Control Table included in the container, as this will help you keep track of the doses: